Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
products:a38x:software:os:debian [2018/08/11 21:13]
artox Add section for upstream (buster)
products:a38x:software:os:debian [2018/10/10 05:00]
baruch [eMMC Software Installation] fix typo
Line 68: Line 68:
 <​code>​ <​code>​
 # Localization # Localization
-d-i debian-installer/​locale select en_GB.UTF-8 +d-i debian-installer/​locale select en_GB
-d-i debian-installer/​language string en+
  
 # Networking # Networking
Line 91: Line 90:
 # Time # Time
 d-i clock-setup/​utc boolean true d-i clock-setup/​utc boolean true
-d-i time/zone string ​Israel+d-i time/zone string ​Europe/​Berlin
 d-i clock-setup/​ntp boolean true d-i clock-setup/​ntp boolean true
  
Line 113: Line 112:
 # Exit Installer # Exit Installer
 d-i finish-install/​reboot_in_progress note d-i finish-install/​reboot_in_progress note
 +
 +# Install U-Boot (u-boot-clearfog-pro-sata.kwb must be placed on the usb drive right next to the preseed.cfg)
 +# d-i preseed/​late_command string dd if=/​hd-media/​u-boot-clearfog-pro-sata.kwb of=/dev/sda bs=512 seek=1 conv=sync
 </​code>​ </​code>​
  
Line 122: Line 124:
 The preseed.cfg file should be placed on the installation drive next to the iso image. In addition the automatic install has to be explicitly enabled through the kernel commandline from the U-Boot console: The preseed.cfg file should be placed on the installation drive next to the iso image. In addition the automatic install has to be explicitly enabled through the kernel commandline from the U-Boot console:
 <​code>​ <​code>​
-setenv bootargs "auto file=/​hd-media/​preseed.cfg"​+setenv bootargs "auto=true file=/​hd-media/​preseed.cfg"​
 # boot into installer, e.g. usb # boot into installer, e.g. usb
 run bootcmd_usb0 run bootcmd_usb0
Line 205: Line 207:
   - Create a directory named ''​extlinux''​ in the USB storage device   - Create a directory named ''​extlinux''​ in the USB storage device
   - Copy the file ''​extlinux.conf''​ from the archive into the ''​extlinux''​ directory   - Copy the file ''​extlinux.conf''​ from the archive into the ''​extlinux''​ directory
-  - Copy the latest Debian image (''​.img.gz''​ suffix) from [[https://​images.solid-build.xyz/​A38X/​Debian/​|here]] to the USB storage device+  - Copy the latest Debian image (''​.img.xz''​ suffix) from [[https://​images.solid-build.xyz/​A38X/​Debian/​|here]] to the USB storage device
   - Set the Clearfog boot select DIP switches to UART boot:   - Set the Clearfog boot select DIP switches to UART boot:
     * For Clearfog Pro set to 11110     * For Clearfog Pro set to 11110